PLCS Test Ends are designed to easily pressure test (up to 150 psi.) any length of PE pipe.

• Insert directly into the open PE pipe end without special preparation.
• Tighten the nut and the grippers lock into position, but release immediately on demand.
• PLCS Test Ends have been tested to the point of pipe failure without pressure release.
• Once set correctly, gripping power increases as the test pressure rises.
• Can be operated together with PLCS Pressure Tight Pipe Pullers to seal both ends of any length section of PE pipe for on-site testing.
• Used together, as above, they provide a total barrier to ingress of water or mud into the PE pipe, under even the worst site conditions.
• Heavy-duty construction in plated steel for rugged durability.
• Minimal maintenance and fully replaceable components.
• Full 1/2" to 8" size IPS size range. Much less expensive than fusing a disposable PE fitting on each time.
• The original Pipe Test End, in service for more than 20 years.